Page History

Overview

The Configuration Wizard is designed to assist administrators in basically setting up the roles on the system, using parameters that are appropriate for most deployments.

It is not enabled on distributed deployments because such setups are more complicated and there is no single set of settings recommended for all deployments.

Even in a single node deployment, it might be possible that the configuration wizard does not produce the intended results. In this case, it is necessary to:

• set up the properties of the infrastructure to match your local implementation
• set up the parameters of each role

Step By Step

In order for the system to automatically set up the roles on the node, follow the steps below.

1. In the web interface, while logged in as administrator, access the Cloud Management section from the left navigation area and then the Configuration Wizard. You might get there automatically, because when the system detects an inconsistency, it will print a message close to the one below:

   Code Block
   We detected that the system is not configured properly, therefore we recommend to go through an automatic configuration procedure. Please press on Next.

2. Click Next to start the Configuration Wizard. The wizard automatically detects the best settings for your system and displays them.
3. All you are required to do is confirm these settings and let the wizard do the work.

4. A message confirming the system configuration success is displayed.

   Code Block
   Your system has been reconfigured and it is ready to use.